Investigations of surface topography of titanium alloy manufactured with the use of 3D print

10th International Symposium Machine and Industrial Design in Mechanical Engineering

工业技术;机械制造

Grobelny, P.^1 ; Legutko, S.^1 ; Habrat, W.^2 ; Furmanski, L.^1

Faculty of Mechanical Engineering and Management, Poznan University of Technology, 3 Piotrowo street, Poznan

60-965, Poland^1

Department of Manufacturing Techniques and Automation, Rzeszow University of Technology, 2 W. Pola street, Rzeszow

35-959, Poland^2

关键词: 3-D printing;    3d prints;    Base plates;    Laser sintering;    Metal parts;    Renishaw;    Surface roughness parameters;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/393/1/012108/pdf
DOI  :  10.1088/1757-899X/393/1/012108

学科分类：工业工程学

来源: IOP

【 摘 要 】

The paper presents the possibilities of 3D printing of chosen titanium alloy for manufacturing ready made parts. Results of examination of the surface topography of material manufactured using the AM 250 device by RENISHAW for laser sintering using the SLM method have been presented. 3D printing of metal parts has the potential to revolutionize the market of manufacturing and supplying parts. It makes it possible to dissipate manufacturing and to produce parts on request at lower cost and less energy consumption. The chosen parameters of the surface topography of titanium alloy under investigations directly after printing can differ depending on the distance from the base plate. Surface roughness parameters, isotropy and Abbott-Firestone curve after machining were also identified.