Analysis of the Coverage Area of the Access Point Using Netspot Simulation

International Symposium on Materials and Electrical Engineering 2017

材料科学;电工学

Suryani, A.T.^1 ; Pantjawati, A.B.^1

Departemen of Electrical Engineering Education, Universitas Pendidikan Indonesia, Jl. Dr. Setiabudhi No. 229, Bandung, Indonesia^1

关键词: Area of coverages;    Coverage area;    research methods;    Research results;    Signal strengths;    Signal to interference ratio;    Signal to interference ratios (SIR);    Student learning;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/384/1/012001/pdf
DOI  :  10.1088/1757-899X/384/1/012001

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

Currently the ease of accessing the internet has become a fundamental requirements primarily a college surroundings. The requirement to always be connected to the internet network is seen with the growing number of access points that are installed to meet these needs. Installation of the access point is often not structured properly so that the area of scoped in the area of coverage is uneven. On the research of the simulation is done against the signal strength of the access point toward the receiver Wi-Fi in the room and the room of the student learning lecturer electrical engineering building FPTK UPI 3 and 4 floors. This research aims to map the territory of blankspot on that location, so that it can be used as a reference for optimizing the placement of access points. The research method used was the experiment through the drive test using Nestpot software. The analysis performed includes: Signal level, Signal-to- Interference ratio, and Quantity of Access point. Experimental results indicate the quality of the reception on location observed is not the same, some point receive very strong signals from more than one access point, while some other point still entered into the realm of blankspot. Of research results also gained some room located near some of the access point are having Signal to Interference Ratio-(SIR).