Method of load calculation of electrical drives of rolling mills during heavy plate manufacturing

9th International Conference on Mechatronics and Manufacturing

机械制造;无线电电子学

Gasiyarov, V.R.^1 ; Radionov, A.A.^1 ; Karandaev, A.S.^1 ; Khramshin, V.R.^2

South Ural State University, 76, Lenin Avenue, Chelyabinsk

454080, Russia^1

Nosov Magnitogorsk State Technical University, 38, Lenin Av., Magnitogorsk

455000, Russia^2

关键词: Accelerated motion;    Calculation data;    Comparative analysis;    Deformation zone;    Electrical drives;    Equivalent currents;    Exact calculations;    Rolling pressure;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/361/1/012014/pdf
DOI  :  10.1088/1757-899X/361/1/012014

来源: IOP

【 摘 要 】

During manufacturing of heavy strips and plates from difficult-to-form steel grades on sheet and wide-strip rolling mills there is a problem of exact calculation of power parameters of rolling. It is pointed out that known methods do not provide required precise information at high deformation zones in a stand. An improved calculation method for rolling pressure and load torque of electrical drive engine is suggested further. This method considers peculiar strain of product in high deformation zones and its accelerated motion in reverse mode. Improved analytical dependences for rolling pressure and load torque of electrical drive are reviewed. Control flow chart and main screen of developed software for calculation of wide- strip rolling parameters are presented. Comparative analysis of calculation data and experimental results of engine equivalent currents during tube steels rolling is made. As a result improved precision of calculation method is justified.