Characterization of Austempered Ferritic Ductile Iron

International Conference on Recent Advances in Materials & Manufacturing Technologies

Dakre, Vinayak S.^1 ; Peshwe, D.R.^1 ; Pathak, S.U.^1 ; Likhite, A.A.^1

Department of Metallurgical and Materials Engineering, Visvesvaraya National Institute of Technology (V.N.I.T.), South Ambazari Road, Maharashtra, Nagpur

440010, India^1

关键词: Austempering process;    Austenitization;    Diamond indenter;    Ferritic matrix;    Furnace cooling;    Graphite nodules;    Pearlitic matrix;    Rockwell hardness tester;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/346/1/012019/pdf
DOI  :  10.1088/1757-899X/346/1/012019

来源: IOP

【 摘 要 】

The ductile iron (DI) has graphite nodules enclose in ferrite envelop in pearlitic matrix. The pearlitic matrix in DI was converted to ferritic matrix through heat treatment. This heat treatment includes austenitization of DI at 900°C for 1h, followed by furnace cooling to 750°C & hold for 1h, then again furnace cooling to 690°C hold for 2h, then samples were allowed to cool in furnace. The new heat treated DI has graphite nodules in ferritic matrix and called as ferritic ductile iron (FDI). Both DIs were austenitized at 900°C for 1h and then quenched into salt bath at 325°C. The samples were soaked in salt bath for 60, 120, 180, 240 and 300 min followed by air cooling. The austempered samples were characterized with help of optical microscopy, SEM and X-ray diffraction analysis. Austempering of ferritic ductile iron resulted in finer ausferrite matrix as compared to ADI. Area fraction of graphite, ferrite and austenite were determining using AXIOVISION-SE64 software. Area fraction of graphite was more in FDI than that of as cast DI. The area fraction of graphite remains unaffected due to austempering heat treatment. Ausferritic matrix coarsened (feathered) with increasing in austempering time for both DI and FDI. Bulk hardness test was carried on Rockwell Hardness Tester with load of 150 kgf and diamond indenter. Hardness obtained in as cast DI is 28 HRC which decreased to 6 HRC in FDI due conversion of pearlitic matrix to ferritic matrix. Hardness is improved by austempering process.