Performance of the electrical generator cell by the ferrous alloys of printed circuit board scrap and Iron Metal 1020

2nd International Conference on Oleo and Petrochemical Engineering

Sahan, Y.^1 ; Sudarsono, S.^1 ; Silviana, E.^1 ; Chairul^1 ; Wisrayetti^1

Department of Chemical Engineering, University of Riau, Pekanbaru

28293, Indonesia^1

关键词: Electric power;    Electrical generators;    Electrode pairs;    Iron metal;    NaCl concentration;    NaCl solution;    Printed circuit board scrap;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/345/1/012038/pdf
DOI  :  10.1088/1757-899X/345/1/012038

来源: IOP

【 摘 要 】

Galvani cell is one of thealternative energy. This cell can be used as an electric resources. In this research, the generator cell was designed and builds to generate the electric. The generator cell consisted of the iron metal 1020 were used as anode, the ferrous alloys of printed circuit board scrapwas then used as chatode, and NaCl solution as an electrolyte. The aim of this research is to estimate the performance of this generator cell by using variation of NaCl concentration (i.e. 1%, 3%, 5%, 7%, and 9%) with the electrodes pair ( 1 and 8 pairs). The performance of the cell was measured with a multi tester equipment and a LED bulb (5-watt 3Volt). The Results shown that the generator cell can produce the electric power of 3.679 Volt maximally by using NaCl 9% and 8 electrode pairs applied for this condition.