A Low-Cost Hand Trainer Device Based On Microcontroller Platform

International Conference on Applied Electronic and Engineering 2017

无线电电子学;工业技术

Mohammad Sabor, Muhammad Akmal^1 ; Thamrin, M. Norashikin^1

Faculty of Electrical Engineering, Universiti Teknologi Mara, Selangor Shah Alam

40450, Malaysia^1

关键词: Arduino platforms;    Bending sensors;    External actuators;    Gripping force;    Healing process;    Low-cost solution;    Microcontroller platforms;    Stroke patients;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/341/1/012010/pdf
DOI  :  10.1088/1757-899X/341/1/012010

学科分类：工业工程学

来源: IOP

【 摘 要 】

Conventionally, the rehabilitation equipment used in the hospital or recovery center to treat and train the muscle of the stroke patient is implementing the pneumatic or compressed air machine. The main problem caused by this equipment is that the arrangement of the machine is quite complex and the position of it has been locked and fixed, which can cause uncomfortable feeling to the patients throughout the recovery session. Furthermore, the harsh movement from the machine could harm the patient as it does not allow flexibility movement and the use of pneumatic actuator has increased the gripping force towards the patient which could hurt them. Therefore, the main aim of this paper is to propose the development of the Bionic Hand Trainer based on Arduino platform, for a low-cost solution for rehabilitation machine as well as allows flexibility and smooth hand movement for the patients during the healing process. The scope of this work is to replicate the structure of the hand only at the fingers structure that is the phalanges part, which inclusive the proximal, intermediate and distal of the fingers. In order to do this, a hand glove is designed by equipping with flex sensors at every finger and connected them to the Arduino platform. The movement of the hand will motorize the movement of the dummy hand that has been controlled by the servo motors, which have been equipped along the phalanges part. As a result, the bending flex sensors due to the movement of the fingers has doubled up the rotation of the servo motors to mimic this movement at the dummy hand. The voltage output from the bending sensors are ranging from 0 volt to 5 volts, which are suitable for low-cost hand trainer device implementation. Through this system, the patient will have the power to control their gripping operation slowly without having a painful force from the external actuators throughout the rehabilitation process.