Study of effective utilization of iron ore sinter through arc plasma

7th National Conference on Processing and Characterization of Materials

Swain, Biswajit^1 ; Samal, S.K.^1 ; Mohanty, M.K.^1 ; Behera, A.^1 ; Mishra, S.C.^1

Metallurgical and Materials Engineering Department, N.I.T Rourkela, India^1

关键词: Arc plasma;    Charge composition;    Comparative studies;    Cost of productions;    High temperature metallurgical process;    Iron-making industry;    Mineral composition;    Wet chemical analysis;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/338/1/012022/pdf
DOI  :  10.1088/1757-899X/338/1/012022

来源: IOP

【 摘 要 】

Generation of fines is common in mining, sizing, and beneficiation and also in high-temperature metallurgical processes as the disintegration of agglomerate/compact occurs. Extraction of metallic iron from ore fines is one of the challenging aspects of iron making industries as the liberation of fines blocks, the charge burden porosity and hence hinders the reduction rate. Along with size factor, mineral composition plays a vital role in the extraction process; particularly silica. As silica has the very high tendency towards iron oxide, at comparatively low temperature, the activity of silica should be suppressed to prevent silicate phases. Adjustment of such conditions is controlled by addition of lime, but sometimes excessive slag generation increases the cost of production. In the present work, carbothermic reduction of partially reduced iron bearing pellets has been melted through 20 KW DC arc plasma furnace, and a comparative study has been made for considering different slag chemistry approaches. Pellets as aforementioned are made available from Patnaik Steel and Alloys Ltd, Odisha, having high silica content ore fines (of about 8.6%) as obtained from the chemical analysis. X-Ray analysis and optical image analyzer result of sinter thus obtained reveal that fayalite phase has major fractional value. Smelting works were done for sinter with/without adjustment of slag chemistry, where argon and nitrogen were used as plasma forming gases. A range of recovery rates (between 87-94%) is achieved by charge composition, ionizing gases, and smelting duration. It is observed that use of nitrogen as plasma forming gas increases the recovery rate than that of using only argon plasma; due to high energy flux of nitrogen which increases the enthalpy due to its diatomicity. A maximum recovery rate of about 94% is achieved for process duration of 13minutes utilizing nitrogen plasma. Smelting of charge with the addition of hydrated lime targeting melilite as final slag resulted in the formation of metallic iron as confirmed from XRD and XRF analyses. In the other hand, ferrosilicon is liberated in the metallic parts where smelting of charge was done without adjustment of slag chemistry. Both metal and slag thus obtained are characterized by XRD, XRF, microhardness and wet chemical analysis suitably.