Influence of the pressure applied to make LATP pellets

International Conference on Mechanical Engineering and Applied Composite Materials

机械制造;材料科学

Lu, Xiaojuan^1

Department of Environmental Science and Engineering, North China Electric Power University, Mailbox 253, No.689 Huadian Road, Baoding, Hebei, China^1

关键词: High pressure;    Impedance analyzer;    Low pressures;    Nasicon;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/307/1/012044/pdf
DOI  :  10.1088/1757-899X/307/1/012044

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

NASICON structured Li1+xAlxTi2-x(PO4)3(0.1≤x≤0.7) powders were prepared by hydrothermal synthesis method and the pressure applied to press the powders into pellets was investigated in this study. The conductivity was measured by an impedance analyzer and the microstructures were examined by SEM. The variation trend with Al amount was almost identical for LATP pressed at high pressure and low pressure. Both the total conductivities of LATP prepared at high pressures and low pressures peaked at x=0.6. The conductivities of LATP pressed at high pressures were all higher than those at low pressures. The reason was mainly attributed to the denser microstructures achieved at higher pressure.