Development of a software-hardware complex for studying the process of grinding by a pendulum deformer

6th International Conference: Modern Technologies for Non-Destructive Testing

Borisov, A.P.^1

Altai State Technical University, Barnaul, Russia^1

关键词: Angle of deviation;    Angle sensors;    Automatic mode;    Grinding process;    Non-contact angle;    Software and hardwares;    Support surfaces;    Supporting surfaces;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/289/1/012004/pdf
DOI  :  10.1088/1757-899X/289/1/012004

来源: IOP

【 摘 要 】

The article is devoted to the development of a software and hardware complex for investigating the grinding process on a pendulum deformer. The hardware part of this complex is the Raspberry Pi model 2B platform, to which a contactless angle sensor is connected, which allows to obtain data on the angle of deviation of the pendulum surface, usb-cameras, which allow to obtain grain images before and after grinding, and stepping motors allowing lifting of the pendulum surface and adjust the clearance between the pendulum and the supporting surfaces. The program part of the complex is written in C # and allows receiving data from the sensor and usb-cameras, processing the received data, and also controlling the synchronous-step motors in manual and automatic mode. The conducted studies show that the rational mode is the deviation of the pendulum surface by an angle of 400, and the location of the grain in the central zone of the support surface, regardless of the orientation of the grain in space. Also, due to the non-contact angle sensor, energy consumption for grinding, speed and acceleration of the pendulum surface, as well as vitreousness of grain and the energy consumption are calculated. With the help of photographs obtained from usb cameras, the work of a pendulum deformer based on the Rebinder formula and calculation of the grain area before and after grinding is determined.