The FEM Simulation on End Mill of Plastic Doors and Windows Corner Cleaning Based on Deform-3D

4th International Conference on Mechanical, Materials and Manufacturing

材料科学;机械制造

Li, Guoping^1 ; Huang, Zhenyong^1 ; Wang, Xiaohui^1

School of Mechanical Engineering, University of Jinan, Jinan

250022, China^1

关键词: 3-d modeling;    Cleaning efficiency;    Cleaning process;    FEM simulations;    Milling process;    Orthogonal experiment design;    Rotating speed;    Theoretical values;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/272/1/012009/pdf
DOI  :  10.1088/1757-899X/272/1/012009

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

In the plastic doors and windows corner cleaning process, the rotating speed, the feed rate and the milling cutter diameter are the main factors that affect the efficiency and quality of the of corner cleaning. In this paper, SolidWorks will be used to establish the 3D model of end mills, and use Deform-3D to research the end mill milling process. And using orthogonal experiment design method to analyze the effect of rotating speed, the feed rate and the milling cutter diameter on the axial force variation, and to get the overall trend of axial force and the selection of various parameters according to the influence of axial force change. Finally, simulate milling experiment used to get the actual axial force data to verify the reliability of the FEM simulation model. And the conclusion obtained in this paper has important theoretical value in improving the plastic doors and windows corner cleaning efficiency and quality.