Torsional Restraint Problem of Steel Cold-Formed Beams Restrained By Planar Members

World Multidisciplinary Civil Engineering-Architecture-Urban Planning Symposium - WMCAUS

土木建筑工程

Balázs, Ivan^1 ; Melcher, Jindich^1 ; Peek, Ondej^1

Institute of Metal and Timber Structures, Faculty of Civil Engineering, Brno University of Technology, Veveí 331/95, Brno

602 00, Czech Republic^1

关键词: Buckling resistance;    Cold-formed steel beams;    Experimental analysis;    Finite element method softwares;    Lateral restraint;    Rotational stiffness;    Shear stiffness;    Thin-walled members;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/245/3/032057/pdf
DOI  :  10.1088/1757-899X/245/3/032057

学科分类：土木及结构工程学

来源: IOP

【 摘 要 】

The effect of continuous or discrete lateral and torsional restraints of metal thinwalled members along their spans can positively influence their buckling resistance and thus contribute to more economical structural design. The prevention of displacement and rotation of the cross-section results in stabilization of the member. The restraints can practically be provided e.g. by planar members of cladding supported by metal members (purlins, girts). The rate of stabilization of a member can be quantified using values of shear and rotational stiffness provided by the adjacent planar members. While the lateral restraint effected by certain shear stiffness can be often considered as sufficient, the complete torsional restraint can be safely considered in some practical cases only. Otherwise the values of the appropriate rotational stiffness provided by adjacent planar members may not be satisfactory to ensure full torsional restraint and only incomplete restraint is available. Its verification should be performed using theoretical and experimental analyses. The paper focuses on problem of steel thin-walled coldformed beams stabilized by planar members and investigates the effect of the magnitude of the rotational stiffness provided by the planar members on the resistance of the steel members. Cold-formed steel beams supporting planar members of cladding are considered. Full lateral restraint and incomplete torsional restraint are assumed. Numerical analyses performed using a finite element method software indicate considerable influence of the torsional restraint on the buckling resistance of a steel thin-walled member. Utilization of the torsional restraint in the frame of sizing of a stabilized beam can result in more efficient structural design. The paper quantifies this effect for some selected cases and summarizes results of numerical analysis.