Evaluation of Foaming Performance of Bitumen Modified with the Addition of Surface Active Agent

World Multidisciplinary Civil Engineering-Architecture-Urban Planning Symposium - WMCAUS

土木建筑工程

Chomicz-Kowalska, Anna^1 ; Mrugala, Justyna^1 ; Maciejewski, Krzysztof^1

Department of Transportation Engineering, Faculty of Civil Engineering and Architecture, Kielce University of Technology, Al. Tysiclecia Pastwa Polskiego 7, Kielce

25-314, Poland^1

关键词: Adhesion performance;    Adhesion promoter;    Chemical additive;    Performance tests;    Positive impacts;    Processing temperature;    Rheological property;    Warm mix asphalts;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/245/3/032086/pdf
DOI  :  10.1088/1757-899X/245/3/032086

学科分类：土木及结构工程学

来源: IOP

【 摘 要 】

The article presents the analysis of the performance of foamed bitumen modified using surface active agents. Although, bitumen foaming permits production of asphalt concrete and other asphalt mix types without using chemical additives in significantly reduced temperatures, the decrease in processing temperatures still impacts the adhesion performance and bitumen coating of aggregates in final mixes. Therefore, in some cases it may be feasible to incorporate adhesion promoters and surface active agents into warm and half-warm mixes with foamed bitumen to increase their service life and resilience. Because of the various nature of the available surface active agents, varying bitumen compatibility and their possible impact on the rheological properties of bitumen, the introduction of surface active agents may significantly alter the bitumen foaming performance. The tests included basic performance tests of bitumen before and after foaming. The two tested bitumen were designated as 35/50 and 50/70 penetration grade binders, which were modified with a surface active agent widely used for improving mixture workability, compactibility and adhesion in a wide range of asphalt mixes and techniques, specifically Warm Mix Asphalt. Alongside to the reference unmodified bitumen, binders with 0.2%, 0.4% and 0.6% surface active agent concentration were tested. The analysis has shown a positive influence of the modifier on the foaming performance of both of the base bitumen increasing their maximum expansion ratio and bitumen foam halflife. In the investigations, it was found that the improvement was dependent on the bitumen type and modifier content. The improved expansion ratio and foam half-life has a positive impact on the aggregate coating and adhesion, which together with the adhesion promoting action of the modifier will have a combined positive effect on the quality of produced final asphalt mixes.