Simulation analyzing the influence of cutting HT250 by self-prepared Si3N4 insert at different feed rate

2017 3rd International Conference on Applied Materials and Manufacturing Technology

Wang, Bo^1,2 ; Zhang, Yang^1 ; Liang, Jian-Nong^1

Zhuhai College of Jilin University, Zhuhai

519041, China^1

School of Electro-mechanical Engineering, Guangdong University of Technology, Guangzhou

510006, China^2

关键词: Cutting forces;    Cutting properties;    Feed-rates;    Finite element software;    Metal cutting process;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/242/1/012042/pdf
DOI  :  10.1088/1757-899X/242/1/012042

来源: IOP

【 摘 要 】

Metal cutting process is an extremely complicated problem. Using the commercial finite element software (Deform), the process has been reliably simulated. In this paper, the process of cutting HT250 by self-prepared Si3N4 insert was simulated at different feed rate base on Finite Element Method (FEM). After simulation, the results of cutting force and temperature were availably obtained. The influence of cutting properties at different feed rate was effectively predicted through analysing these results.