Hot Runner Mold Design of Fan Diverter Parts

2nd International Conference on Automation, Control and Robotics Engineering

工业技术;计算机科学;无线电电子学

Juan, D.J.^1,2 ; Cheng, Y.L.^1,2

Department of Power Mechanical Engineering, National Formosa University, Taiwan^1

No.64, Wenhua Rd., Huwei Township, Yunlin County

632, Taiwan^2

关键词: Hot runners;    Material cost;    Mold designs;    Plastic steel;    Production cycle;    Production yield;    Steering gear;    Stock-preparation;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/235/1/012012/pdf
DOI  :  10.1088/1757-899X/235/1/012012

来源: IOP

【 摘 要 】

In this study, we discuss the case of plastic parts for the production of fan steering gear shaft parts injection molding, and use POM plastic steel to produce plastic parts from traditional cold runners. Because of the parts have a hole, which need side slide. The runner produce more waste after plastic parts injection make the runner waste account for the cost is relatively high, the cost of stock preparation is relatively increased when the product quantity demanded is great. After the crushing treatment of the waste, the backfill will affect the quality, and in the crushing process, the volume generated will make the operator to withstand up to 130 dB of noise. The actual test results show that the production cycle reduce 6.25%, while the production yield increase by about 5% and material costs reduced by 2% . It can be recovered within a year, not to mention the increase of the quality and reduction the noise on the staff of the benefit is impossible to estimate.