Effects of organoclay to miscibility, mechanical and thermal properties of poly(lactic acid) and propylene-ethylene copolymer blends

Innovation in Polymer Science and Technology 2016

材料科学;化学

Wacharawichanant, S.^1 ; Ounyai, C.^1 ; Rassamee, P.^1

Department of Chemical Engineering, Faculty of Engineering and Industrial Technology, Silpakorn University, Nakhon Pathom

73000, Thailand^1

关键词: Ethylene copolymer;    Mechanical and thermal properties;    Melting point temperature;    Morphology analysis;    Poly lactic acid;    Polylactic acids;    Thermal and mechanical properties;    Two-phase separation;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/223/1/012016/pdf
DOI  :  10.1088/1757-899X/223/1/012016

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

The effects of propylene-ethylene copolymer (PEC or PEC3300) and clay surface modified with 25-30 wt% of trimethylstearyl ammonium (Clay-TSA) on morphology, thermal and mechanical properties of poly(lactic acid) (PLA) were investigated. The morphology analysis showed PLA/PEC3300 blends clearly demonstrated a two-phase separation of dispersed phase and the matrix phase and the addition of Clay-TSA could improve the miscibility of PLA and PEC3300 blends due to the decreased of the domain sizes of dispersed PEC3300 phase in the polymer matrix. From X-ray diffraction analysis showed the intercalation of PLA chains inside the Clay-TSA and this result implied that Clay-TSA platelets acted as an effective compatibilizer. The tensile properties showed the strain at break of PLA was improved after adding PEC3300 while Young's modulus, tensile strength and storage modulus decreased. The addition of Clay-TSA could improve Young's modulus of PLA/PEC3300 blends. The addition of Clay-TSA 7 phr showed the maximum of Young's modulus of PLA/PEC3300/Clay-TSA composites. The thermal properties found that the addition of PEC3300 and Clay-TSA did not change significantly on the glass transition temperature and melting point temperature of PLA. The percent of crystallinity of PLA decreased with increasing PEC content. The thermal stability of PLA improved after adding PEC3300.