Innovative Ideas in Science 2016 | |
Research on the injectors remanufacturing | |
Daraba, D.^1 ; Alexandrescu, I.M.^1 ; Daraba, C.^2 | |
Technical University of Cluj-Napoca, North University Center of Baia Mare, Engineering and Technology Management Department, Dr. Victor Babes Street, no. 62A, Baia Mare | |
430083, Romania^1 | |
Darmold SRL, Vasile Lucaciu Street no. 162, Baia Mare | |
430402, Romania^2 | |
关键词: Cleaning process; Control methodology; Control process; Electronic microscopes; Microscopic analysis; Remanufacturing process; Verification method; Verification process; | |
Others : https://iopscience.iop.org/article/10.1088/1757-899X/200/1/012036/pdf DOI : 10.1088/1757-899X/200/1/012036 |
|
来源: IOP | |
【 摘 要 】
During the remanufacturing process, the injector body - after disassembling and cleaning process - should be subjected to some strict control processes, both visually and by an electronic microscope, for evidencing any defects that may occur on the sealing surface of the injector body and the atomizer. In this paper we present the path followed by an injector body in the process of remanufacturing, exemplifying the verification method of roughness and hardness of the sealing surfaces, as well as the microscopic analysis of the sealing surface areas around the inlet. These checks can indicate which path the injector body has to follow during the remanufacturing. The control methodology of the injector body, that is established on the basis of this research, helps preventing some defective injector bodies to enter into the remanufacturing process, thus reducing to a minimum the number of remanufactured injectors to be declared non-conforming after final verification process.
【 预 览 】
Files | Size | Format | View |
---|---|---|---|
Research on the injectors remanufacturing | 682KB | download |