Optimization of Drilling Parameters for Reducing the Burr Height in Machining the Silicon Carbide Particle (SiCp) Coated with Multi Wall Carbon Nano Tubes (MWCNT) Reinforced in Aluminum Alloy (A 356) Using Meta Modeling Approach

Frontiers in Automobile and Mechanical Engineering

Sangeetha, M.^1 ; Prakash, S.^2

Department of Mechanical Engineering, Sathyabama University, Tamil Nadu, Chennai, India^1

School of Mechanical Engineering, Sathyabama University, Tamil Nadu, Chennai, India^2

关键词: Burr height;    Desirability function;    Optimization modeling;    Optimized combinations;    Silicon carbide particles;    Taguchi design;    Taguchi experimental design;    Vertical machining centers;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/197/1/012070/pdf
DOI  :  10.1088/1757-899X/197/1/012070

来源: IOP

【 摘 要 】

This paper explains the optimization of drilling parameters using meta modeling approach to reduce the burr height while machining Silicon Carbide Particle (SiCp) coated with Multi Wall Carbon Nano Tubes (MWCNT) and reinforced in aluminum alloy (A 356). The specimen is prepared by the combination of sonication and stir casting processes. The volume fraction of MWCNT used is 1.5% and the volume fraction of SiCp is 10%. The combination of input parameters for drilling the holes is designed using Taguchi experimental design technique. The input parameters chosen for drilling operations are spindle speed, feed rate and drill diameter. The ranges of input parameters are listed in Table 1. The tools used for drilling operation are made up of solid carbide drill bit. Meta model is a mathematical and statistical model whose second-order model can be fitted by factorial design. The optimization model can be improved significantly by the second-order model compared to the first-order model. Twenty-seven holes are drilled using vertical machining center in the prepared specimen (A 356/MWCNT coated SiCp). Desirability function shows the optimized values of input parameters to obtain minimum burr height. Meta modeling approach is used to design a model using input parameters and output response burr height. The residuals plot shows the predicted values are closer to the measured values. This plot explains that the Meta model is adequately used to predict the burr height. The optimized values of input parameters for obtaining minimum burr height are the combination of high speed, low feed and low drill diameter. The minimum value of burr height observed in this experiment is 0.002mm and it is obtained in the optimized combination of N3, f1 and d1.