Mechanical Properties Studies of Components Formulation for Mixing Process Contain of Polypropylene, Polyethylene, and Aluminium Powder

1st Annual Applied Science and Engineering Conference

工业技术;自然科学

Hamsi, A.^1 ; Dinzi, R.^2

Mechanical Engineering, University of Sumatera Utara, Medan

20155, Indonesia^1

Electrical Engineering, University of Sumatera Utara, Medan

20155, Indonesia^2

关键词: Aluminium powder;    Filling time;    Homogenity;    Inhomogeneities;    Mixing process;    Small particles;    Three component;    Toxic reactions;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/180/1/012006/pdf
DOI  :  10.1088/1757-899X/180/1/012006

来源: IOP

【 摘 要 】

Certain powder and others components can induce toxic reactions if not properly handled in the mixing stage. During handling, the small particles can become airborne and be trapped in the lungs, another concern is inhomogeneities in the mixing process. Uniform quantities of the particles of the components are needed in all portions of the mixture. This paper reports the results of mechanical properties studies of mixing three components formulation for mixing process. Contain of Polyethylene (PE), Polyprophylene (PP) and Aluminium Powder. Powder mixer, Autodesk mold flow and computer based on excell method was carried out to study the influence of each formulation component on the flow %, PE 20% and Aluminium powder 2%. Macroscopic optic and macro photo was carried out to identify the homogenity of mixing, tensile test for identify the strength of component after mixing. Finally the optimal tensile test with composition PP 785,PE 20% and Aluminium powder 2% at speed 52 rpm, temperature 1500C, the tensile strength 20,92 N/mm2. At temperature 1600C, speed 100 rpm the optimum tensile strength 17,91 N/mm2. The result of simulation autodesk mold flow adviser the filling time 6 seconds. Otherwise on manual hot hidraulic press the time of filling 10 seconds.