Identification of the Quality Spot Welding used Non Destructive Test-Ultrasonic Testing: (Effect of Welding Time)

1st Annual Applied Science and Engineering Conference

工业技术;自然科学

Sifa, A.^1 ; Endramawan, T.^1 ; Badruzzaman^1

Politeknik Negeri Indramayu, Indonesia^1

关键词: Experimental testing;    Identification techniques;    Manufacturing process;    Non-destructive test;    Resistance spot welding;    Time-differences;    Welding current;    Welding process parameters;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/180/1/012101/pdf
DOI  :  10.1088/1757-899X/180/1/012101

来源: IOP

【 摘 要 】

Resistance Spot Welding (RSW) is frequently used as one way of welding is used in the manufacturing process, especially in the automotive industry [4][5][6][7]. Several parameters influence the process of welding points. To determine the quality of a welding job needs to be tested, either by damaging or testing without damage, in this study conducted experimental testing the quality of welding or identify quality of the nugget by using Non-Destructive Test (NDT) -Ultrasonic Testing (UT), in which the identification of the quality of the welding is done with parameter thickness of worksheet after welding using NDT-UT with use same material worksheet and have more thickness of worksheet, the thickness of the worksheet single plate 1mm, with the capability of propagation Ultrasonic Testing (UT) standard limited> 3 mm [1], welding process parameters such as the time difference between 1-10s and the welding current of 8 KV, visually Heat Affected Zone ( HAZ ) have different results due to the length of time of welding. UT uses a probe that is used with a frequency of 4 MHz, diameter 10 mm, range 100 and the couplant used is oil. Identification techniques using drop 6dB, with sound velocity 2267 m / s of Fe, with the result that the effect of the Welding time affect the size of the HAZ, identification with the lowest time 1s show results capable identified joined through NDT - UT.