Neutron radiography and tomography investigations on the porosity of the as-cast titanium femoral stem

11th Joint Conference on Chemistry in Conjunction with the 4th Regional Biomaterials Scientific Meeting

材料科学;化学;生物科学

Sutiyoko^1,2 ; Suyitno^1 ; Mahardika, M.^1 ; Akbar, F.^3 ; Juliani^3 ; Setiawan^3 ; Baroto^3

Department of Mechanical and Industrial Engineering, Gadjah Mada University, Yogyakarta, Indonesia^1

Foundry Department, Manufacturing Polytechnic of Ceper, Klaten, Indonesia^2

National Nuclear Energy Agency (BATAN), South Tangerang, Indonesia^3

关键词: Femoral stems;    Gating system designs;    Internal porosity;    Neutron tomography;    Porosity distributions;    Sub-surface porosity;    Subsurface regions;    Vertical centrifugal castings;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/172/1/012057/pdf
DOI  :  10.1088/1757-899X/172/1/012057

来源: IOP

【 摘 要 】

Gating system design in the centrifugal casting is one of the factors that influence the porosity of the femoral stem. The objective of this research is to analysis the porosity in the as-cast titanium femoral stem by neutron radiography and tomography. Three gating system designs which in three-ingates, four-ingates, and four-ingates by inversed position of the femoral stem were casted by a vertical centrifugal casting in investment mold. The porosity distribution in the titanium femoral stem was investigated by the neutron radiography film and followed by neutron tomography. The results indicate that there are large internal porosity in the subsurface region on both of the four-ingates designs but only small internal porosity on the three-ingates design. The large porosity also takes place in largest part of the femoral stem at all of the gating system designs. The product may be rejected due to the sub-surface porosity. The three-ingates design has the smallest risk on the reject product.