Single-phase frequency converter

International Conference on Applied Sciences 2016

Baciu, I.^1 ; Cunan, C.D.^1

Politehnica University of Timisoara, Department of Electrical Engineering and Industrial Informatics, 5 Revolution Street, Hunedoara

331128, Romania^1

关键词: Charging current;    Command sequences;    Continuous voltages;    Current amplifier;    Different voltages;    Galvanic separations;    Voltage transformer;    Voltage variation;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/163/1/012036/pdf
DOI  :  10.1088/1757-899X/163/1/012036

来源: IOP

【 摘 要 】

The paper presents a continuous voltage inverter - AC (12V / 230V) made with IGBT and two-stage voltage transformer. The sequence control transistors is achieved using a ring counter whose clock signal is obtained with a monostable circuit LM 555. The frequency of the clock signal can be adjustment with a potentiometer that modifies the charging current of the capacitor which causes constant monostable circuit time. Command sequence consists of 8 intervals of which 6 are assigned to command four transistors and two for the period break at the beginning and end of the sequence control. To obtain an alternation consisting of two different voltage level, two transistors will be comanded, connected to different windings of the transformer and the one connected to the winding providing lower voltage must be comanded twice. The output of the numerator goes through an inverter type MOS and a current amplifier with bipolar transistor.To achieve galvanic separation, an optocoupler will be used for each IGBT transistor, while protection is achieved with resistance and diode circuit. At the end there is connected an LC filter for smoothing voltage variations.