20th Innovative Manufacturing Engineering and Energy Conference | |
Analysis of lead twist in modern high-performance grinding methods | |
机械制造;能源学 | |
Kundrák, J.^1 ; Gyáni, K.^1 ; Felho, C.^1 ; Markopoulos, A.P.^2 ; Deszpoth, I.^1 | |
Institute of Manufacturing Science, University of Miskolc, Miskolc-Egyetemváros | |
H-3515, Hungary^1 | |
Section of Manufacturing Technology, School of Mechanical Engineering, National Technical University of Athens, Heroon Polytechniou 9, Athens | |
15780, Greece^2 | |
关键词: Free surfaces; Geometrical analysis; Grinding methods; Industrial experience; Modern high performance; Quality requirements; Quick-point grinding; Single grains; | |
Others : https://iopscience.iop.org/article/10.1088/1757-899X/161/1/012005/pdf DOI : 10.1088/1757-899X/161/1/012005 |
|
来源: IOP | |
【 摘 要 】
According to quality requirements of road vehicles shafts, which bear dynamic seals, twisted-pattern micro-geometrical topography is not allowed. It is a question whether newer modern grinding methods - such as quick-point grinding and peel grinding - could provide twist- free topography. According to industrial experience, twist-free surfaces can be made, however with certain settings, same twist occurs. In this paper it is proved by detailed chip-geometrical analysis that the topography generated by the new procedures is theoretically twist-patterned because of the feeding motion of the CBN tool. The presented investigation was carried out by a single-grain wheel model and computer simulation.
【 预 览 】
Files | Size | Format | View |
---|---|---|---|
Analysis of lead twist in modern high-performance grinding methods | 1750KB | download |