Studies on Effect of Fused Deposition Modelling Process Parameters on Ultimate Tensile Strength and Dimensional Accuracy of Nylon

International Conference on Advances in Materials and Manufacturing Applications 2016

Basavaraj, C.K.^1 ; Vishwas, M.^2

Department of Industrial Engineering and Management, Siddaganga Institute of Technology, Karnataka, Tumkur

572103, India^1

Dept. of Industrial Engineering and Management, Siddaganga Institute of Technology, Karnataka, Tumkur

572103, India^2

关键词: Dimensional accuracy;    Fused deposition modeling;    Fused deposition modelling;    L9 orthogonal arrays;    Nylon;    Response characteristic;    Response parameters;    Ultimate tensile strength;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/149/1/012035/pdf
DOI  :  10.1088/1757-899X/149/1/012035

来源: IOP

【 摘 要 】

This paper discusses the process parameters for fused deposition modelling (FDM). Layer thickness, Orientation angle and shell thickness are the process variables considered for studies. Ultimate tensile strength, dimensional accuracy and manufacturing time are the response parameters. For number of experimental runs the taguchi's L9 orthogonal array is used. Taguchis S/N ratio was used to identify a set of process parameters which give good results for respective response characteristics. Effectiveness of each parameter is investigated by using analysis of variance. The material used for the studies of process parameter is Nylon.