Effect of heat treatment duration on tribological behavior of electroless Ni-(high)P coatings

International Conference on Advances in Materials and Manufacturing Applications 2016

Biswas, A.^1,2 ; Das, S.K.^1 ; Sahoo, P.^1,2

Mechanical Engineering Department, Jadavpur University, Kolkata

700032, India^1

Centre of Excellence on Phase Transformation and Product Characterisation, TEQIP- II, Jadavpur University, Kolkata

700032, India^2

关键词: Autocatalytic chemical reaction;    Coefficient of frictions;    Effect of heat treatments;    Electroless coating;    Electroless Ni-P coating;    Electroless nickel coatings;    Energy dispersive x-ray analysis (EDX);    X-ray diffraction analyses (XRD);   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/149/1/012045/pdf
DOI  :  10.1088/1757-899X/149/1/012045

来源: IOP

【 摘 要 】

Electroless nickel coating occurs through an autocatalytic chemical reaction and without the aid of electricity. From tribological perspective, it is recommended due to its high hardness, wear resistance, lubricity and corrosion resistance properties. In this paper electroless Ni-P coatings with high phosphorous weight percentages are developed on mild steel (AISI 1040) substrates. The coatings are subjected to heat treatment at 300°C and 500°C for time durations up to 4 hours. The effect of heat treatment duration on the hardness as well as tribological properties is discussed in detail. Hardness is measured in a micro hardness tester while the tribological tests are carried out on a pin-on-disc tribotester. Wear is reported in the form of wear rates of the sample subjected to the test. As expected, heat treatment of electroless Ni-P coating results in enhancement in its hardness which in turn increases its wear resistance. The present study also finds that duration of heat treatment has quite an effect on the properties of the coating. Increase in heat treatment time in general results in increase in the hardness of the coating. Coefficient of friction is also found to be lesser for the samples heat treated for longer durations (4 hour). However, in case of wear, similar trend is not observed. Instead samples heat treated for 2 to 3 hour display better wear resistance compared to the same heat treated for 4 hour duration. The microstructure of the coating is also carried out to ensure about its proper development. From scanning electron microscopy (SEM), the coating is found to possess the conventional nodular structure while energy dispersive X-ray analysis (EDX) shows that the phosphorous content in the coating to be greater than 9%. This means that the current coating belongs to the high phosphorous category. From X-ray diffraction analysis (XRD), it is found that coating is amorphous in as-deposited condition but transforms into a crystalline structure with heat treatment.