Development of Alkali Activated Geopolymer Masonry Blocks

International Conference on Advances in Materials and Manufacturing Applications 2016

Venugopal, K.^1 ; Radhakrishna^2 ; Sasalatti, Vinod^2

Dept. of Civil Engg, Jain University, Karnataka, Bengaluru, India^1

Dept of Civil Engg, RV College of Engg, Affiliated to V.T.U, Karnataka, Bengaluru, India^2

关键词: GGBFS;    Ground granulated blast-furnace slag (GGBFS);    Lateral confinement;    Manufactured sand;    Masonry units;    Non-conventional materials;    Structural masonry;    Traditional masonries;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/149/1/012072/pdf
DOI  :  10.1088/1757-899X/149/1/012072

来源: IOP

【 摘 要 】

Cement masonry units are not considered as sustainable since their production involves consumption of fuel, cement and natural resources and therefore it is essential to find alternatives. This paper reports on making of geopolymer solid & hollow blocks and masonry prisms using non conventional materials like fly ash, ground granulated blast furnace slag (GGBFS) and manufactured sand and curing at ambient temperature. They were tested for water absorption, initial rate of water absorption, dry density, dimensionality, compressive, flexural and bond-strength which were tested for bond strength with and without lateral confinement, modulus of elasticity, alternative drying & wetting and masonry efficiency. The properties of geopolymer blocks were found superior to traditional masonry blocks and the masonry efficiency was found to increase with decrease in thickness of cement mortar joints. There was marginal difference in strength between rendered and unrendered geopolymer masonry blocks. The percentage weight gain after 7 cycles was less than 6% and the percentage reduction in strength of geopolymer solid blocks and hollow blocks were 26% and 28% respectively. Since the properties of geopolymer blocks are comparatively better than the traditional masonry they can be strongly recommended for structural masonry.