Mathematical simulation of a profile cutter as a surface of revolution

International Conference on Mechanical Engineering, Automation and Control Systems 2015

机械制造;无线电电子学;计算机科学

Bubenchikov, A.M.^1 ; Kazakavitschyus, S.M.^1 ; Shcherbakov, N.R.^1

National Research Tomsk State University, 36, Lenina ave., Tomsk

634050, Russia^1

关键词: Axial displacements;    Circular cross-sections;    Mathematical simulations;    Surface of revolution;    Surface processing;    Time of processing;    Transmission gear;    Transmission mechanisms;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/124/1/012095/pdf
DOI  :  10.1088/1757-899X/124/1/012095

学科分类：计算机科学（综合）

来源: IOP

【 摘 要 】

Various types of cutters (spherical, toroidal, etc.) are used in surface processing of parts of a transmission mechanism. The cost of a special profile tool is somewhat higher than that of such cutters. But the increase in the cost of the tool is compensated by a significant reduction in the time of processing parts. The present paper deals with a mathematical model of a profile cutter surface (as a surface of revolution) for processing parts of a cylindrical transmission gear with an eccentrically cycloidal gearing (EC-gearing). A computer program for determining radii of the cutter's circular cross sections for a given set of axial displacements was created.