Evaluation of Electrostatic Force on Bipolar Charged Electret

14th International Conference on Micro and Nanotechnology for Power Generation and Energy Conversion Applications

物理学;能源学

Sonoda, K.^1 ; Minami, K.^1 ; Miwatani, N.^1 ; Fujita, T.^1 ; Kanda, K.^1 ; Maenaka, K.^1

Department of EECS, Graduate School of Engineering, University of Hyogo, 2167 Shosha, Hyogo, Himeji

671-2280, Japan^1

关键词: Bias conditions;    DC bias;    Energy Harvester;    Load resistances;    Monopolar;    Output power;    Vibration amplitude;    Vibration energy harvesters;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/557/1/012092/pdf
DOI  :  10.1088/1742-6596/557/1/012092

来源: IOP

【 摘 要 】

This paper presents an evaluation of an electrostatic vibration energy harvester with the bipolar charged electret. The energy harvester with the size of 13 × 12 × 1.2 mm3was fabricated. The output power of the bipolar charged with ±250 V harvester was 9 μW when the acceleration was 1.4 g at 352 Hz with 0.9 MΩ load resistance. The effectiveness against the velocity-damped resonant-generator (VDRG) limit was 2.5%. The electrostatic forces of the actual device with DC bias, which simulates charged electret with monopolar and bipolar were experimentally and numerically verified. We estimated the electrostatic force by measuring the vibration amplitude versus applied acceleration of the electret mass. As a result, we investigated the bipolar charged device can reduce the effect of electrostatic force as low as no bias condition. The numerical model of the energy harvester considering the electrostatic force by FEM static analysis was also established. The comparison between the numerical model and the measurement results showed a similar inclination.