Numerical Studies on a Rotor with Distributed Suction for Noise Reduction

The Science of Making Torque from Wind 2014

Lutz, Thorsten^1 ; Arnold, Benjamin^1 ; Wolf, Alexander^1 ; Krämer, Ewald^1

Institute of Aerodynamics and Gas Dynamics, University of Stuttgart, Pfaffenwaldring 21, 70550 Stuttgart, Germany^1

关键词: Active flow control;    Aeroacoustic analysis;    Boundary layer suction;    Numerical calculation;    Numerical investigations;    Onshore wind turbine;    Suction distributions;    Three dimensional effect;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/524/1/012122/pdf
DOI  :  10.1088/1742-6596/524/1/012122

来源: IOP

【 摘 要 】

Minimizing the flow-induced noise is an important issue in the design of modern onshore wind turbines. There is a number of proven passive means to reduce the aeroacoustic noise, such as the implementation of serrations, porous trailing edges or the aeroacoustic airfoil design. The noise emission can be further reduced by active flow control techniques. In the present study the impact of distributed boundary layer suction on the noise emission of an airfoil and a complete rotor is investigated. Aerodynamic and aeroacoustic wind tunnel tests were performed for the NACA 64-418 airfoil and supplemented by numerical calculations. The aeroacoustic analyses have been conducted by means of the institute's Rnoise prediction scheme. The 2D studies have shown that noise reductions of 5 dB can be achieved by suction at moderate mass flow rates. To study the impact of three-dimensional effects numerical investigations have been conducted on the example of the generic NREL 5MW rotor with suction applied in the outer part of the blade. The predictions for the complete rotor provided smaller benefits compared to those for the isolated airfoil, mainly because the examined suction configurations were not optimized with respect to the extent of the suction patch and suction distribution.