Analysis of transient state in HTS tapes under ripple DC load current

11th European Conference on Applied Superconductivity

Stepien, M.^1 ; Grzesik, B.^1

Silesian University of Technology, Faculty of Electrical Engineering, B. Krzywoustego 2, Gliwice

44-100, Poland^1

关键词: Data acquisition system;    Electronic current;    Inverse models;    Measured parameters;    Measurements of;    National Instruments;    Ripple component;    Transient state;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/507/2/022036/pdf
DOI  :  10.1088/1742-6596/507/2/022036

来源: IOP

【 摘 要 】

The paper concerns the analysis of transient state (quench transition) in HTS tapes loaded with the current having DC component together with a ripple component. Two shapes of the ripple were taken into account: sinusoidal and triangular. Very often HTS tape connected to a power electronic current supply (i.e. superconducting coil for SMES) that delivers DC current with ripples and it needs to be examined under such conditions. Additionally, measurements of electrical (and thermal) parameters under such ripple excitation is useful to tape characterization in broad range of load currents. The results presented in the paper were obtained using test bench which contains programmable DC supply and National Instruments data acquisition system. Voltage drops and load currents were measured vs. time. Analysis of measured parameters as a function of the current was used to tape description with quench dynamics taken into account. Results of measurements were also used to comparison with the results of numerical modelling based on FEM. Presented provisional results show possibility to use results of measurements in transient state to prepare inverse models of superconductors and their detailed numerical modelling.