Investigation of application of flanging process for obtaining convex parts

International Conference on Innovations and Prospects of Development of Mining Machinery and Electrical Engineering 2018

矿业工程;电工学

Demyanenko, E.G.^1 ; Popov, I.P.^1

Samara State Aerospace University, Samara

443086, Russia^1

关键词: Axisymmetric;    Convex parts;    Flanging process;    Geometric dimensions;    Minimal thickness;    Technological process;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/194/6/062009/pdf
DOI  :  10.1088/1755-1315/194/6/062009

来源: IOP

【 摘 要 】

In this paper the new method of forming based on flanging is investigated. The obtained experimental results supported the theoretical conclusions and allowed us to define geometric dimensions of a blank for forming of the thin axisymmetric parts with minimal thickness fluctuations. This analysis serves as a foundation for further design of the technological process.