Fixed Bed Combustion of Biomass: Particulate Matter Mitigation by Optimising Temperature and Fuel Particle Size

2018 4th International Conference on Renewable Energy Technologies

Cicilia Kemunto, Mesa^1 ; Wang, Enyu^1 ; Gou, Xiang^1 ; Imran Shah, Ali^1 ; Odhiambo Adwek, George^1

School of Energy and Environmental Engineering, Hebei University of Technology, Tianjin

300401, China^1

关键词: Aerodynamic diameters;    Combustion temperatures;    Condensed organic compounds;    Different particle sizes;    Fixed-bed combustion;    Incomplete combustion;    Particulate Matter;    Particulate matter emissions;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/168/1/012038/pdf
DOI  :  10.1088/1755-1315/168/1/012038

来源: IOP

【 摘 要 】

Experimental results are presented on the particulate matter emissions from a fixed bed combustion reactor chamber combusting two types of ambient dried biomass fuels, six different particle sizes (0.044-0.149mm) in seven different temperature zones (600-1200 °C).The fuel was ground into various particle sizes and the temperature of combustion was varied for investigation on the emission due from the various parameters. Measurements were made for particulate matter (PM) during the whole phase of combustion by a portable soot analyzer. The PM investigated here is total catch that includes solid particles of elemental carbon and fuel and condensed organic compounds due from incomplete combustion which are less than or equal to 10μm in aerodynamic diameter. The fuel was ground by a grinder and sieved into different sizes by a shake sieve with various mesh sizes. It was found that the PM emission from both biomass fuels was significantly dependent on the temperature of combustion which in turn dictated the residence time in the combustion chamber. The mean PM mass emissions from wood and peanut shell were established. The optimum combustion temperature was identified to be 900°C attracting PM mitigation of up to 63%. The least PM producing particle size for peanut shell and wood fuel was determined to be 0.149mm combusting at 12000C and 0.074mm combusting at 6000C respectively with capacity to mitigate PM production by a maximum of 30-49%. However the effect of the two parameters was established to be mutually dependent. The time taken for complete combustion reduced steadily with the increase of the temperature from 360 seconds at 600°C to 150 seconds at 1200°C.