Fish passage through hydropower turbines: Simulating blade strike using the discrete element method

27th IAHR Symposium on Hydraulic Machinery and Systems

Richmond, M.C.^1 ; Romero-Gomez, P.^1

Pacific Northwest National Laboratory, Earth Systems Science Division, Hydrology Group, Richland

WA

99352, United States^1

关键词: Detached eddy simulations;    Development and testing;    Engineering design process;    Hydraulic conditions;    Hydraulic performance;    Particle trajectories;    Strike probabilities;    Temporal and spatial variability;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/22/6/062010/pdf
DOI  :  10.1088/1755-1315/22/6/062010

来源: IOP

【 摘 要 】

Among the hazardous hydraulic conditions affecting anadromous and resident fish during their passage though hydro-turbines two common physical processes can lead to injury and mortality: collisions/blade-strike and rapid decompression. Several methods are currently available to evaluate these stressors in installed turbines, e.g. using live fish or autonomous sensor devices, and in reduced-scale physical models, e.g. registering collisions from plastic beads. However, a priori estimates with computational modeling approaches applied early in the process of turbine design can facilitate the development of fish-friendly turbines. In the present study, we evaluated the frequency of blade strike and rapid pressure change by modeling potential fish trajectories with the Discrete Element Method (DEM) applied to fish-like composite particles. In the DEM approach, particles are subjected to realistic hydraulic conditions simulated with computational fluid dynamics (CFD), and particle-structure interactions-representing fish collisions with turbine components such as blades-are explicitly recorded and accounted for in the calculation of particle trajectories. We conducted transient CFD simulations by setting the runner in motion and allowing for unsteady turbulence using detached eddy simulation (DES), as compared to the conventional practice of simulating the system in steady state (which was also done here for comparison). While both schemes yielded comparable bulk hydraulic performance values, transient conditions exhibited an improvement in describing flow temporal and spatial variability. We released streamtraces (in the steady flow solution) and DEM particles (transient solution) at the same locations where sensor fish (SF) were released in previous field studies of the advanced turbine unit. The streamtrace- based results showed a better agreement with SF data than the DEM-based nadir pressures did because the former accounted for the turbulent dispersion at the intake using an empirical method, but the unsteady simulation underestimated turbulence in the intake. However, the DEM-based strike frequency is more representative of blade-strike probability as compared to the steady solution, mainly because DEM particles accounted for the full fish length and width, thus resolving (instead of modeling) the collision event. Although further development and testing is needed, the DEM method shows promise as another tool in the engineering design process to develop turbines that can achieve fish-friendly hydraulic conditions.