Calculation of Load-bearing Capacity of Tubula Anchor of Friction Type

International science and technology conference "Earth science"

Zubkov, A.A.^1 ; Kutlubaev, I.M.^2 ; Muhamedjarova, M.S.^3

LLC UralEnergoResurs, room 12, 12 Metallurgov prospect, Magnitogorsk

455000, Russia^1

Department of Mining Machines and Transport-Technological Complexes, FGBOU VO 'Nosov Magnitogorsk State Technical University', 38 Lenina prospect, Magnitogorsk

455000, Russia^2

FGBOU VO 'Nosov Magnitogorsk State Technical University', 38 Lenina prospect, Magnitogorsk

455000, Russia^3

关键词: Borehole models;    Cross sectional profiles;    Distributed loads;    Force interaction;    Interaction schemes;    Load-bearing capacity;    Parameters characterizing;    Physical simulation;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/272/2/022052/pdf
DOI  :  10.1088/1755-1315/272/2/022052

来源: IOP

【 摘 要 】

The load-bearing capacity of a rod of a tubular anchor of a friction type (friction-type anchor) is determined by the nature of its interaction with the walls of the hole. The preliminary (estimated) calculation of this indicator is difficult because of the lack of information about the deformed state of the rod. The proposed interaction scheme assumes coupling only over a part of the cross-sectional profile. Force factors are represented by concentrated and distributed loads. On the basis of accepted assumptions, a mathematical model which indicates rod-hole force interaction is formed. The determination of the parameters characterizing the adopted interaction scheme is based on the solution of the obtained nonlinear equations. The physical simulation of the process of installing the anchor in the borehole model was performed. The accepted scheme of interaction of a rod - borehole is experimentally confirmed. The results of numerical simulation have large convergence with experimental data.