Wall roughness influence on the NPSH characteristics of centrifugal pumps

29th IAHR Symposium on Hydraulic Machinery and Systems

Lipej, Andrej^1 ; Muhi, Simon^1 ; Mitruevski, Duko^2

University of Novo Mesto, Faculty of Mechanical Engineering, Slovenia^1

SM-Pumps, Slovenia^2

关键词: Cavitation characteristics;    Computational fluid dynamics analysis;    Dynamic characteristics;    Experimental development;    Finishing surfaces;    Numerical calculation;    Time-dependent problem;    Turbulent models;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/240/3/032019/pdf
DOI  :  10.1088/1755-1315/240/3/032019

来源: IOP

【 摘 要 】

Pumps are very important and very widespread energetic machines. They are used in all branches of industry. Pumps are also a major consumer of electricity and therefore their development is even more important. From theoretical through experimental development in the last decades, a quantity of research has focused on numerical analysis. These are used to optimize all kinds of characteristics, from energy and cavitation, to dynamic characteristics. At the beginning of Computational Fluid Dynamics (CFD) analyses were related to the physical model (potential flow, Euler equation, Navier-Stokes equations). Subsequently, a lot of research was carried out in the field of various turbulent models. With the launch of high performance multi-processor computers, more and more time-dependent problems have been analysed. All the above mentioned research was carried out with numerical calculations on smooth surfaces. The fact is that in reality there is always some roughness on wet surfaces, depending on the material, the technology of production of certain parts of machines and finishing surface treatment. In the article, we give preliminary results of numerical analyses of centrifugal pumps, where the roughness of the walls was taken into account. The analyses were completed for different types of pumps, with different roughnesses and for different characteristics. First he effect of the roughness on the efficiency is shown, further the cavitation characteristics were analysed. The basic idea for research comes from the fact that there are still many cases where the matching of the results of the measurements and the results of numerical analyses are not perfect. One of the possible reasons can be the roughness of the walls.