Numerical analysis of a Kaplan turbine model during transient operation

29th IAHR Symposium on Hydraulic Machinery and Systems

Iovnel, R.G.^1^2 ; Bucur, D.M.^1 ; Dunca, G.^1 ; Cervantes, M.J.^2

University Politehnica of Bucharest, Romania^1

Luleå University of Technology, Luleå, Sweden^2

关键词: Best efficiency point;    Electrical grids;    Experimental values;    Hydropower plants;    Operating points;    Transient operation;    Unsteady pressures;    Velocity profiles;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/240/2/022046/pdf
DOI  :  10.1088/1755-1315/240/2/022046

来源: IOP

【 摘 要 】

Hydropower plants are currently being intensively employed for electrical grid regulation. As a consequence, the frequency of start/stops and load variations is considerably increasing, leading to the operation of hydraulic turbines under improper conditions. During the last years, studies have focused on Francis turbines. The present paper aims to investigate a Kaplan turbine model. The flow through the turbine is modelled during transient operation, from the best efficiency point to a part load operating point, using a moving mesh for the guide vane displacement. The simulations are validated against experimental velocity profiles. A time step sensitivity analysis is performed in order to determine the optimum discretization time. The possibility of using large time steps is explored. The numerically simulated unsteady pressure pulsations on the runner blades are analysed. The influence of the inlet boundary conditions on the accuracy of numerical simulations is studied. The results show that a linear flow rate variation defined during the guide vane closure leads to an overestimation of the turbine head compared to the experimental value due to an overestimation of losses. The second type of boundary conditions, a constant total pressure, results in an underestimation of the flow rate compared to the experimental value due again to an overestimation of the losses.