Computer simulation, analysis of force and temperature-speed parameters of the process of combined machining of Al-Mg-Sc alloys

2nd International Conference on Mechanical Engineering and Applied Composite Materials

机械制造;材料工程

Sidelnikov, S.B.^1 ; Yakivyuk, O.V.^1 ; Baranov, V.N.^2 ; Konstantinov, I.L.^1 ; Dovzhenko, I.N.^1 ; Lopatina, E.S.^3 ; Voroshilov, D.S.^1 ; Samchuk, A.P.^1 ; Frolov, V.A.^1

Department of Metal Forming, School of Non-Ferrous Metals and Material Science, Siberian Federal University, Krasnoyarsk

660025, Russia^1

Department of Common Metallurgy, School of Non-Ferrous Metals and Material Science, Siberian Federal University, Krasnoyarsk

660025, Russia^2

Department of Metallurgy and Heat Treatment of Metals Named after V.S. Biront, School of Non-Ferrous Metals and Material Science, Siberian Federal University, Krasnoyarsk

660025, Russia^3

关键词: Combined machining;    Drawing ratios;    Power parameters;    Semi-finished products;    Welding wires;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/544/1/012018/pdf
DOI  :  10.1088/1757-899X/544/1/012018

来源: IOP

【 摘 要 】

The results of studies of the combined processing of alloys of the Al-Mg-Sc system with known rheological properties under various temperature-rate and deformation conditions are presented. A computer model of the combined machining process was created and the DEFORM 3D complex was used to analyze the metal flow, the distribution of the strain rate and the temperature of the metal over the cross section of the workpiece when receiving round bars of various diameters. The results of the research were used to develop the production technology of welding wire from alloys of the Al-Mg-Sc system.