Quality Control with Six Sigma DMAIC and Grey Failure Mode Effect Anaysis (FMEA) : A Review

1st International Conference on Industrial and Manufacturing Engineering

工业技术（总论）;机械制造

Ishak, Aulia^1 ; Siregar, Khawarita^1 ; Asfriyati^2 ; Naibaho, Hansen^1

Industrial Engineering Department, Faculty of Engineering Universitas Sumatera Utara, Jl. Almamater Kampus USU, Medan

20155, Indonesia^1

Public Health Faculty, Universitas Sumatera Utara, Jl. Universitas, Kampus USU, Medan, Indonesia^2

关键词: Academic research;    Anecdotal evidences;    Case-studies;    Manufacturing industries;    Production sector;    Quality of product;    Service companies;    Six sigma dmaic;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/505/1/012057/pdf
DOI  :  10.1088/1757-899X/505/1/012057

学科分类：工业工程学

来源: IOP

【 摘 要 】

Currently, manufacturing industry competes in improving the quality of products produced, High demand leads to competition in similar manufacturing industries. Therefore, it becomes a challenge for companies to reduce product abnormality. Six sigma is a very early and potential ideology in this field. In production sector accross the world, six sigma is well known and its asset is being taken for improving capacity and character achievement and also to make the course sturdy to quality alteration. The effectiveness of Six Sigma is well supported by anecdotal evidence. However, academic research on Six Sigma is still in its early stage. The review of Six Sigma and Grey FMEA case studies that is achieved in modest scale corporation, service company and product construction is showed in this paper.