Cutting tools simulation with different parameter

1st International Conference on Industrial and Manufacturing Engineering

工业技术（总论）;机械制造

Siregar, Ikhsan^1 ; Saedon, Juri Bin^2 ; Adenan, Mohd Shariman^2

Department of Industrial Engineering, Universitas Sumatera Utara, Medan, Indonesia^1

Universiti Teknologi MARA, Shah Alam, Malaysia^2

关键词: Adverse effect;    Analysis and simulation;    Design geometry;    Micro milling forces;    Micro milling tool;    Optimal parameter;    simulation;    Structural details;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/505/1/012042/pdf
DOI  :  10.1088/1757-899X/505/1/012042

学科分类：工业工程学

来源: IOP

【 摘 要 】

Previous studies have described that micro-devices either with analysis and simulation viewing that micro tools a very central role in micro machines, and microtool geometry has a direct upshot on the value of the last process. Design geometry micro milling tools for was taken from macro tools, where can be assumed that adverse effects occurring during the process of milling is analogical, which basically means the formation of chip and the process of kinematic is in the kind of tools. In this research also mentioned that there is often structural detail that inhibits miniaturization. To define the optimal parameters in the micro milling then that should be taken into account is to take effect of minimum chip, cutting refraction, and spindle run-out, development is required for the model of micro milling forces.