Probing the Nature of Cellulosic Fibre Interfaces with Fluorescence Resonance Energy Transfer

Fiber bonding;FRET;Fluorescence microscopy;Fibers;Cellulose

Thomson, Cameron Ian ; Chemistry and Biochemistry

University:Georgia Institute of Technology

Department:Chemistry and Biochemistry

关键词: Fiber bonding;    FRET;    Fluorescence microscopy;    Fibers;    Cellulose;   

Others  :  https://smartech.gatech.edu/bitstream/1853/16277/1/Thomson_Cameron_I_200708_phd.pdf

美国|英语

来源: SMARTech Repository

【 摘 要 】

The material properties of fibre networks and fibre reinforced composites are strongly influenced by fibre-fibre interactions. Stress transfer between load bearing elements in such materials is often dictated by the nature of the fibre-fibre interface.Inter-fibre bonding is solely responsible for internal cohesion in paper, because all stresses transferred between fibres operate through fibre-fibre bonds. . The future development of cellulosic fibre materials will require an improved understanding of the fibre-fibre interface.Fluorescence resonance energy transfer (FRET) was proposed as a new tool for the study of fibre interfaces.A protocol for covalent linkage of fluorophores to natural and regenerated cellulosic fibres was developed and the absorptive and emissive properties of these dyes were characterized.The fluorescent response of these dyed fibres in paper sheets was studied using steady-state fluorescence spectroscopy. Fluorescence micrographs of fibre crossings on glass slides were analyzed using the FRETN correction algorithm.Energy transfer from coumarin dyed fibres to fluorescein dyed fibres at the interface was observed.The FRETN surfaces for spruce and viscose rayon fibre crossings were distinctly different. The FRET microscopy method was able to detect statistically significant differences in spruce fibre interface development when fibre fraction and wet pressing were varied. The coalescence of natural cellulosic fibre interfaces during drying was also observed with the technique. Polysaccharide films were employed as model systems for the natural and regenerated cellulose fibre interfaces.It was found that pressing cellulose films did not result in significantly increased FRETN either due to resistance to deformation or the inability to participate in interdiffusion.Conversely, xylan films demonstrated a drastic increase in the FRETN signal with increased wet pressing. These results support the previously observed differences between regenerated cellulose fibres and natural wood fibres.The results of the FRETN analysis of the polysaccharide film model systems suggest that lower molecular weight amorphous carbohydrates are likely to be significant contributors to fibre interface development.