A geometric study of liquid retention in open-cell metal foams

Metal foams;water retention;kelvin problem;x-ray computed tomography;geometry

Bock, Jessica J. ; Jacobi ; Anthony M.

关键词: Metal foams;    water retention;    kelvin problem;    x-ray computed tomography;    geometry;   

Others  :  https://www.ideals.illinois.edu/bitstream/handle/2142/24274/Bock_Jessica.pdf?sequence=1&isAllowed=y

美国|英语

来源: The Illinois Digital Environment for Access to Learning and Scholarship

【 摘 要 】

Open-cell metal foams show promise as an emerging novel material for heat exchanger applications. The high surface-area-to-volume ratio suggests increased compactness and decrease in weight of heat exchanger designs.However, the metal foam structure appears conducive to condensate retention, which would degenerate heat transfer performance.This research investigates the condensate retention behavior of aluminum open-cell metal foams through the use of static dip tests and geometrical classification via X-ray Micro-Computed Tomography.Aluminum open-cell metal foam samples of 5, 10, 20, and 40 pores per inch (PPI), all having a void fraction greater than 90%, were included in this investigation.In order to model the condensate retention behavior of metal foams, a clearer understanding of the geometry was required.After exploring the ideal geometries presented in the open literature, X-ray Micro-Computed Tomography was employed to classify the actual geometry of the metal foam samples.The images obtained were analyzed using specialized software from which geometric information including strut length and pore shapes were extracted.The results discerned a high variability in ligament length, as well as features supporting the ideal geometry known as the Weaire-Phelan unit cell.The static dip tests consisted of submerging the metal foam samples in a liquid, then allowing gravity-induced drainage until steady-state was reached and the liquid remaining in the metal foam sample was measured.Three different liquids, water, ethylene glycol, and 91% isopropyl alcohol, were employed.The behaviors of untreated samples were compared to samples subjected to a Beomite surface treatment process, and no significant differences in retention behavior were discovered.The dip test results revealed two distinct regions of condensate retention, each holding approximately half of the total liquid retained by the sample.As expected, condensate retention increased as the pores sizes decreased.A model based on surface tension was developed to predict the condensate retention in the metal foam samples and verified using a regular mesh.Applying the model to both the ideal and actual metal foam geometries showed good agreement with the dip test results in this study.