Magnetic gears present significant structural design challenges, because metallic/electrically conductive structures are highly undesirable as they would lead to significant efficiency reductions. Additionally, most non-electrically conductive structural materials have low thermal conductivity, which makes cooling the gear difficult. These limitations are of particular significant in magnetic gear's modulator structures. NASA Glenn has shown that pole pieces on the order of 1 to 2 mm thick optimize magnetic gears specific torque. These thin pole pieces however see very large magnetic forces and modulator structural limitations prevent the use of magnetically optimum pole pieces. The best solution to this issue to date has been the use of carbon fiber retaining rings on the external surface of the modulator, however this solution increases ring modulator airgap, resulting in a torque reduction from the optimum design. The pole pieces are also the largest sources of losses in magnetic gears. Because the modulator is nestled between the ring and sun gear extraction of this heat is a difficult problem and the modulator structure has to be designed to dissipate this heat load. In the presentation I will present the design of NASA Glenn's 4th magnetic gear's modulator in detail that uses a combination of 3D fiber reinforced nylon, IM7 carbon fiber, and pitch base cn80 fiber to close both structurally and thermally.
PDF
download
878987797
028-85220240
