Subtask 1.23 - Mercury Removal from Barite the Oil Industry

Holmes, Michael ; Nyberg, Carolyn ; Brandt, Katie ; Eylands, Kurt ; Fiala, Nathan ; Dunham, Grant

University of North Dakota

关键词: Removal;    Barite;    02 Petroleum;    Density;    Well Drilling;   

DOI  :  10.2172/986898
RP-ID  :  None
RP-ID  :  FC26-98FT40320
RP-ID  :  986898

美国|英语

来源: UNT Digital Library

【 摘 要 】

Drilling muds are used by the oil and gas industry to provide a seal and to float rock chips to the surface during the drilling process. Barite (naturally occurring barium sulfate ore) is commonly used as a weighting agent additive in drilling muds because it is chemically nonreactive and has a high specific gravity (between 4.2 and 4.25 at 20 C). Because of environmental concerns, barite used by the oil and gas industry in the Gulf of Mexico must be certified to contain less than 1 mg/kg of mercury. Faced with these regulations, the U.S. Gulf Coast oil industry has looked to foreign sources of low-mercury barite, primarily India and China. These sources tend to have high-grade barite deposits and relatively inexpensive domestic transportation costs; as of late, however, U.S. purchasers have been forced to pay increasing costs for shipping to U.S. grinding plants. The objective of this project was to demonstrate two mercury removal techniques for high-mercury barite sources. Two barite samples of unique origins underwent processing to reduce mercury to required levels. The chemical treatment with dilute acid removed a portion of the mercury in both barite samples. The desired concentration of 1 mg/kg was achieved in both barite samples. An economic analysis indicates that thermal removal of mercury would not significantly add to the cost of barite processing, making higher-mercury barite a viable alternative to more expensive barite sources that contain lower concentrations of mercury.