Full Core 3-D Simulation of a Partial MOX LWR Core

Bays, S. ; Skerjanc, W. ; Pope, M.

Idaho National Laboratory

关键词: Lattice Code;    Forecasting;    Irradiation;    Uranium Core Simulator;    Core Simulator;   

DOI  :  10.2172/961928
RP-ID  :  INL/EXT-09-15913
RP-ID  :  DE-AC07-99ID-13727
RP-ID  :  961928

美国|英语

来源: UNT Digital Library

【 摘 要 】

A comparative analysis and comparison of results obtained between 2-D lattice calculations and 3-D full core nodal calculations, in the frame of MOX fuel design, was conducted. This study revealed a set of advantages and disadvantages, with respect to each method, which can be used to guide the level of accuracy desired for future fuel and fuel cycle calculations. For the purpose of isotopic generation for fuel cycle analyses, the approach of using a 2-D lattice code (i.e., fuel assembly in infinite lattice) gave reasonable predictions of uranium and plutonium isotope concentrations at the predicted 3-D core simulation batch average discharge burnup. However, it was found that the 2-D lattice calculation can under-predict the power of pins located along a shared edge between MOX and UO2 by as much as 20%. In this analysis, this error did not occur in the peak pin. However, this was a coincidence and does not rule out the possibility that the peak pin could occur in a lattice position with high calculation uncertainty in future un-optimized studies. Another important consideration in realistic fuel design is the prediction of the peak axial burnup and neutron fluence. The use of 3-D core simulation gave peak burnup conditions, at the pellet level, to be approximately 1.4 times greater than what can be predicted using back-of-the-envelope assumptions of average specific power and irradiation time.