Suppression of pool fires with HRC-125 in a simulated engine nacelle.

Keyser, David R. (INS, Inc., Lexington Park, MD) ; Hewson, John C.

Sandia National Laboratories

关键词: Fluid Mechanics;    Ponds;    Fire Extinguishers;    Fires;    Engines;   

DOI  :  10.2172/912659
RP-ID  :  SAND2007-3442
RP-ID  :  AC04-94AL85000
RP-ID  :  912659

美国|英语

来源: UNT Digital Library

【 摘 要 】

CFD simulations are conducted to predict the distribution of fire suppressant in an engine nacelle and to predict the suppression of pool fires by the application of this suppressant. In the baseline configuration, which is based on an installed system, suppressant is injected through four nozzles at a rate fast enough to suppress all simulated pool fires. Variations that reduce the mass of the suppression system (reducing the impact of the suppression system on meeting mission needs) are considered, including a reduction in the rate of suppressant injection, a reduction in the mass of suppressant and a reduction in the number of nozzles. In general, these variations should work to reduce the effectiveness of the suppression system, but the CFD results point out certain changes that have negligible impact, at least for the range of phenomena considered here. The results are compared with measurements where available. Comparisons with suppressant measurements are reasonable. A series of twenty-three fire suppression tests were conducted to check the predictions. The pre-test predictions were generally successful in identifying the range of successful suppression tests. In two separate cases, each where one nozzle of the suppression system was capped, the simulation results did indicate a failure to suppress for a condition where the tests indicated successful suppression. When the test-suppressant discharge rate was reduced by roughly 25%, the tests were in agreement with the predictions. That is, the simulations predict a failure to suppress slightly before observed in these cases.