Evaluation of the Transient Hydrologic Source Term for the Cambric Underground Nuclear Test at Frenchman Flat, Nevada test Site

Carle, S F ; Maxwell, R M ; Pawloski, G A ; Shumaker, D E ; Tompson, A B ; Zavarin, M

Lawrence Livermore National Laboratory

关键词: Nuclear Test Sites;    Pumping;    Monitoring;    Transport;    38 Radiation Chemistry, Radiochemistry, And Nuclear Chemistry;   

DOI  :  10.2172/907859
RP-ID  :  UCRL-TR-226916
RP-ID  :  W-7405-ENG-48
RP-ID  :  907859

美国|英语

来源: UNT Digital Library

【 摘 要 】

The objective of Phase II HST work is to develop a better understanding of the evolution of the HST for 1,000 years at the CAMBRIC underground nuclear test site in Frenchman Flat at the NTS. This work provides a better understanding of activities as they actually occurred, incorporates improvements based on recent data acquisition, and provides a basis to use the CAMBRIC site for model validation and monitoring activities as required by the UGTA Project. CAMBRIC was the only test in Frenchman Flat detonated under the water table and best represents a fully saturated environment. These simulations are part of a broad Phase II Frenchman Flat Corrective Action Unit (CAU) flow and transport modeling effort being conducted by the Department of Energy (DOE) Underground Test Area (UGTA) Project. HST simulations provide, either directly or indirectly, the source term used in the CAU model to calculate a contaminant boundary. Work described in this report augments Phase I HST calculations at CAMBRIC conducted by Tompson et al. (1999) and Pawloski et al. (2001). Phase II HST calculations have been organized to calculate source terms under two scenarios: (1) A representation of the transient flow and radionuclide release behavior at the CAMBRIC site that is more specific than Tompson et al. (1999). This model reflects the influence of the background hydraulic gradient, residual test heat, pumping experiment, and ditch recharge, and takes into account improved data sources and modeling approaches developed since the previous efforts. Collectively, this approach will be referred to as the transient CAMBRIC source term. This report describes the development of the transient CAMBRIC HST. (2) A generic release model made under steady-state flow conditions, in the absence of any transient effects, at the same site with the same radiologic source term. This model is for use in the development of simpler release models for the other nine underground test sites in the Frenchman Flat CAU. This approach will be referred to as the steady-state (non-transient) CAMBRIC source term. This work is described in a separate report (Tompson et al., 2005).