THE USE OF COAL COMBUSTION BY-PRODUCTS FOR IN SITU TREATMENT OF ACID MINE DRAINAGE

Canty, Geoffrey A. ; Everett, Jess W.

West Virginia University Research Corporation (United States)

关键词: By-Products;    Aluminium;    Combustion;    Acid Neutralizing Capacity;    Nickel;   

DOI  :  10.2172/837194
RP-ID  :  NONE
RP-ID  :  FC26-98FT40028
RP-ID  :  837194

美国|英语

来源: UNT Digital Library

【 摘 要 】

In 1994 a demonstration project was undertaken to investigate the effectiveness of using CCBs for the in situ treatment of acidic mine water. Actual injection of alkaline material was performed in 1997 with initial positive results; however, the amount of alkalinity added to the system was limited and resulted in short duration treatment. In 1999, a CBRC grant was awarded to further investigate the effectiveness of alkaline injection technology (AIT). Funds were released in fall 2001. In December 2001, 2500 tons of fluidized bed combustion (FBC) ash were injected into the wells used in the 1997 injection project. Post injection monitoring continued for 24 months. During this period the mine chemistry had gone through a series of chemical changes that manifested as stages or ''treatment phases.'' The mine system appeared to be in the midst of reestablishing equilibrium with the partial pressure of mine headspace. Alkalinity and pH appeared to be gradually increasing during this transition. As of December 2003, the pH and alkalinity were roughly 7.3 and 65 ppm, respectively. Metal concentrations were significantly lower than pre-injection levels, but iron and manganese concentrations appeared to be gradually increasing (roughly 30 ppm and 1.25 ppm, respectively). Aluminum, nickel, and zinc were less than pre-injection concentrations and did not appear to be increasing (roughly