CROSS-ROLL FLOW FORMING OF ODS ALLOY HEAT EXCHANGER TUBES FOR HOOP CREEP ENHANCEMENT

Kad, Bimal K.

University of California (United States)

关键词: Research Programs;    Extrusion;    36 Materials Science;    Gas Turbines;    Microstructure;   

DOI  :  10.2172/828172
RP-ID  :  NONE
RP-ID  :  FC26-03NT41985
RP-ID  :  828172

美国|英语

来源: UNT Digital Library

【 摘 要 】

Mechanically alloyed oxide dispersion strengthened (ODS) Fe-Cr-Al alloy thin walled tubes and sheets, produced via powder processing and consolidation methodologies, are promising materials for eventual use at temperatures up to 1200 C in the power generation industry, far above the temperature capabilities of conventional alloys. Target end-uses range from gas turbine combustor liners to high aspect ratio (L/D) heat exchanger tubes. Grain boundary creep processes at service temperatures, particularly those acting in the hoop direction, are the dominant failure mechanisms for such components. The processed microstructure of ODS alloys consists of high aspect ratio grains aligned parallel to the tube axis, a result of dominant axial metal flow which aligns the dispersoid particles and other impurities in the longitudinal direction. The dispersion distribution is unaltered on a micro scale by recrystallization thermal treatments, but the high aspect ratio grain shape typically obtained limits transverse grain spacing and consequently the hoop creep response. Improving hoop creep in ODS-alloy components will require understanding and manipulating the factors that control the recrystallization behavior, and represents a critical materials design and development challenge that must be overcome in order to fully exploit the potential of ODS alloys. The objectives of this program are to (1) increase creep-strength at temperature in ODS-alloy tube and liner components by 100% via, (2) preferential cross-roll flow forming and grain/particle fibering in the critical hoop direction. Recent studies in cross-rolled ODS-alloy sheets (produced from flattened tubes) indicate that transverse creep is significantly enhanced via controlled transverse grain fibering, and similar improvements are expected for cross-rolled tubes. The research program outlined here is iterative in nature and is intended to systematically (1) prescribe extrusion consolidation methodologies via detailed test matrices, (2) examine and identify post-extrusion forming methodologies to create hoop strengthened tubes, which will be (3) evaluated at ''inservice'' loads at service temperatures and environments. This research program is to be conducted in collaboration with the DOE's Oak Ridge National Laboratory and the vested industrial partners Special Metals Corporation. In this second quarter of performance, program activities were initiated for Tasks 2, 3 and 4 and are reported herein. The completion of Task 1 ensures sufficient materials are now available for the remainder of this program.