Erosion Modeling Analysis For Modified DWPF SME Tank | |
LEE, SI | |
Savannah River Site (S.C.) | |
关键词: Stresses; Abrasives; Flow Rate; Radioactive Waste Facilities; Computerized Simulation; | |
DOI : 10.2172/824268 RP-ID : WSRC-TR-2003-00534 RP-ID : AC09-96SR18500 RP-ID : 824268 |
|
美国|英语 | |
来源: UNT Digital Library | |
【 摘 要 】
In support of an erosion evaluation for the modified cooling coil guide and its supporting structure in the DWPF SME vessel, a computational model was developed to identify potential sites of high erosion using the same methodology established by previous work. The erosion mechanism identified in the previous work was applied to the evaluation of high erosion locations representative of the actual flow process in the modified coil guide of the SME vessel, abrasive erosion which occurs by high wall shear of viscous liquid. The results show that primary locations of the highest erosion due to the abrasive wall erosion are at the leading edge of the guide, external surface of the insert plate, the tank floor next to the insert plate of the coil guide support, and the upstream lead-in plate. The present modeling results show a good comparison between the original and the modified cases in terms of high erosion sites, as well as the degree of erosion and the calculated shear stress. Wall she ar of the tank floor is reduced by about 30 per cent because of the new coil support plate. Calculations for the impeller speed lower than 103 rpm in the SME showed similar erosion patterns but significantly reduced wall shear stresses and reduced overall erosion. Comparisons of the 103 rpm results with SME measurements indicated that no significant erosion of the tank floor in the SME is to be expected. Thus, it is recommended that the agitator speed of SME does not exceed 103 rpm.
【 预 览 】
Files | Size | Format | View |
---|---|---|---|
824268.pdf | 5119KB | download |