Intelligent Extruder

AlperEker ; Giammattia, Mark ; Houpt, Paul ; Kumar, Aditya ; Montero, Oscar ; Shah, Minesh ; Silvi, Norberto ; Cribbs, Timothy

General Electronic Company/Corporate Research and Development (United States)

关键词: Feedback;    Extrusion;    Polymers;    36 Materials Science;    Computerized Control Systems;   

DOI  :  10.2172/810724
RP-ID  :  DOE/CH/10972
RP-ID  :  FC07-99CH10972
RP-ID  :  810724

美国|英语

来源: UNT Digital Library

【 摘 要 】

''Intelligent Extruder'' described in this report is a software system and associated support services for monitoring and control of compounding extruders to improve material quality, reduce waste and energy use, with minimal addition of new sensors or changes to the factory floor system components. Emphasis is on process improvements to the mixing, melting and de-volatilization of base resins, fillers, pigments, fire retardants and other additives in the :finishing'' stage of high value added engineering polymer materials. While GE Plastics materials were used for experimental studies throughout the program, the concepts and principles are broadly applicable to other manufacturers materials. The project involved a joint collaboration among GE Global Research, GE Industrial Systems and Coperion Werner & Pleiderer, USA, a major manufacturer of compounding equipment. Scope of the program included development of a algorithms for monitoring process material viscosity without rheological sensors or generating waste streams, a novel detection scheme for rapid detection of process upsets and an adaptive feedback control system to compensate for process upsets where at line adjustments are feasible. Software algorithms were implemented and tested on a laboratory scale extruder (50 lb/hr) at GE Global Research and data from a production scale system (2000 lb/hr) at GE Plastics was used to validate the monitoring and detection software. Although not evaluated experimentally, a new concept for extruder process monitoring through estimation of high frequency drive torque without strain gauges is developed and demonstrated in simulation. A plan to commercialize the software system is outlined, but commercialization has not been completed.