Silicon/Pyrex Planar Microbattery A Silicon Process-Compatible Micro-Power Source

KRAVITZ, STANLEY H. ; INGERSOLL, DAVID ; BELL, NELSON S. ; ZMUDA, SHERRY A. ; SHUL, RANDY J. ; WROBLEWSKI, BRIAN

Sandia National Laboratories

关键词: 25 Energy Storage;    Cathodes;    Cobalt Oxides;    Miniaturization;    Etching;   

DOI  :  10.2172/808609
RP-ID  :  SAND2002-4175
RP-ID  :  AC04-94AL85000
RP-ID  :  808609

美国|英语

来源: UNT Digital Library

【 摘 要 】

The design, fabrication, and performance of a planar microbattery made from a silicon wafer with a bonded lid are presented. The battery is designed with two compartments, separated by four columns of micro-posts. These posts are 3 or 5 micrometers in diameter. The posts permit transport of liquid electrolyte, but stop particles of battery material from each compartment from mixing. The anode and cathode battery compartments, the posts, fill holes, and conductive vias are all made using high-aspect-ratio reactive ion (Bosch) etching. After the silicon wafer is completed, it is anodically bonded or adhesive bonded to a Pyrex{reg_sign} wafer lid. The battery materials are made from micro-disperse particles that are 3-5 micrometers in diameter. The lithium-ion chemistry is microcarbon mesobeads and lithium cobalt oxide. The battery capacity is 1.83 micro-amp-hrs/cm{sup 2} at a discharge rate of 25 microamps.